Started off using the TailScale IP address for the Pi but then did not see any of the computers as clients in the Adguard Home Screen. I would like to use Adguard Home as my DNS but have a bunch of different IP options and have tried some combinations with inconsistent results.

Raspberry Pi 4b with Home Assistant OS and the TailScale Add-On which also has Adguard Home.

Been with Tailscale for a few days and love it so far. If you need to install Docker, you can follow the Quick and Easy Steps to Install Docker on your system.Maybe a simple question but haven’t been able to get this sorted out. To run the container, you can run the following docker run command in your docker host terminal. This guide uses the adguard/adguardhome docker container image. Install Adguard Home with a Docker Run command Those commands will create the volumes that you can map in your docker run command, or docker-compose file. You can create the volumes by typing docker volume create adguard_data and docker volume create adguard_config.

Adding both volumes to your docker host and mapping them to your container will ensure container data and configuration persists between container updates. One for the working data ( /opt/adguardhome/work) and one for the application configuration ( /opt/adguardhome/conf). You can even use this guide to install AdGuard Home on a Raspberry Pi.

This is a quick guide that can be used for most system architectures. It is similar to other network level DNS ad blockers such as Pi-Hole. When a home router is setup to point devices DNS queries to your AdGuard Home installation it will block advertisements for your entire home. It works at the network level and blocks advertisements and internet trackers.

AdGuard Home acts as a recursive DNS resolver.

This article provides the required information to install Adguard Home using Docker. Install Adguard Home with a Docker Compose file.Install Adguard Home with a Docker Run command.Create a Docker Volume for Adguard Home.

Adguard home assistant